As soon as paper is put into the ”Multi Purpose Tray” (side tray), the printer automatically prints from this tray. How can I avoid it? |
 |
Initially “the manual feed” is set on “first”. Therefore, the printer takes paper from this tray, independent from the driver installation.
You can change the initial setting by doing the following steps:
1. Go to “Paper Handling”
2. Select “MP tray Mode” (Cassette)
Then the Multi Purpose Tray is treated like an additional paper cassette.
If the printer does not have any display (like FS-1000), then the change can be made via “KM net ROP” or “KM net for Clients”. Or via Prescribe command:
Please type the following command into the DOS-Box. ( printer requires a parallel connection)
Echo !R! FRPO T0,0; STAT1; EXIT;>lpt1
On the Service status report, the parameter “T0” should be “0”.
You can change the initial setting by doing the following steps:
1. Go to “Paper Handling”
2. Select “MP tray Mode” (Cassette)
Then the Multi Purpose Tray is treated like an additional paper cassette.
If the printer does not have any display (like FS-1000), then the change can be made via “KM net ROP” or “KM net for Clients”. Or via Prescribe command:
Please type the following command into the DOS-Box. ( printer requires a parallel connection)
Echo !R! FRPO T0,0; STAT1; EXIT;>lpt1
On the Service status report, the parameter “T0” should be “0”.